Automatic power-switching function
If the source being played is stopped and the input signal is cut off for 7 to 8 minutes, the subwoofer automatically switches to the standby mode. (When the subwoofer switches to the standby mode by the automatic power- switching function, the power indicator lights up in red.) When you play a source again, the power of the subwoofer turns on automatically by sensing audio signals input to the subwoofer.
This function will operate by sensing a certain level of low frequency input signal. Usually set the AUTO STANDBY switch to the LOW position. However, if the power is not switched on or to the standby mode smoothly, set the switch to the HIGH position. In the HIGH position, the power will turn on even with a low level of input signal. But please be aware that the subwoofer may not switch to the standby mode when there is an extremely low input signal.
*The power might turn on unexpectedly by sensing noise from other appliances. If that occurs, set the AUTO STANDBY switch to the OFF position and use the POWER switch to switch the power between ON and OFF manually.
*This function detects the
*The minutes required to switch the subwoofer to the standby mode might change by sensing noise from other appliances.
This function is available only when the power of the subwoofer is on (by pressing the POWER switch).
Adjusting the subwoofer before use
Before using the subwoofer, adjust the subwoofer to obtain the optimum volume balance between the subwoofer and the front
speakers by following the procedures described below.
Rear panel
3
POWER
ON
OFF
VOLUME | |
0 | 10 |
AUTO |
|
STANDBY |
|
HIGH |
|
LOW |
|
OFF |
|
INPUT | /MONO |
POWER | |
ON |
|
OFF |
|
VOLUME
1, 5
0 | 10 | ||
AUTO |
| ||
STANDBY |
| ||
|
|
| |
HIGH |
|
|
|
LOW |
|
|
|
OFF |
|
|
|
INPUT | /MONO |
