PLACING THE SPEAKER

Place the speaker on TV whose top is flat or on the floor under the TV or inside the TV rack so that it is stabilized.

When placing the speaker on top of the TV, to prevent the speaker from falling down, put the provided fasteners at four points on the bottom of the speaker and the top of the TV.

Front L
Front R
Subwoofer
NS-C325
Center
surround back

1

Fastener

2

surround

 

Notes

 

• Do not place the speaker on top of the TV whose area is

•

smaller than the bottom area of the speaker. If placed,

 

the speaker may drop out causing an injury to you.

 

• Do not place the speaker on top of the TV with an

•

inclination.

 

•Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength.

Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop. This speaker features a magnetically shielded design, but there is still a chance that placing it too close to a TV set might impair picture color or create a buzzing noise. Should this happen, move the speaker away from the TV set.

CONNECTIONS TO YOUR AMPLIFIER

Before making connections, make sure that the amplifier is switched off.

■CONNECTIONS

Loosen Tighten
Black (–)
Red (+)

 

+

–

NS-C325

•Connect the screw-type input terminals at the rear of the speaker to the speaker output terminals of the amplifier (or receiver) with the speaker cable.

•Connect the (+) terminals on the amplifier (or receiver) and the speaker using one side of the cable. Connect the

(–) terminals on both components using the other side of the cable.

•Connect the speaker to the center terminals of your amplifier, making sure not to reverse the polarity (+, –). If the speaker is connected with reversed polarity, the sound will be unnatural and lack bass.

How to connect:
1Loosen the knob.

2Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.

CENTER

+

–

Amplifier or
E-2Receiver
3Insert the bare wire.4Tighten the knob and secure the cables.

Test the firmness of the connection by pulling lightly on the cables at the terminal.

Note:

Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them.