Yamaha PCY100 Setting Up

As shown in the diagram, set up your pad unit on an electronic drum rack or a standard cymbal stand

(such as a Yamaha CS Series product).

1Using a tuning key (optional), loosen the stopper’s key bolt. (See Figure 1.)

2Remove the wing nut, the two felt pads, and the bolt cover from the cymbal holder. (See Figure 2.)

3Place the stopper on the cymbal holder. (See Figure 3.)

• If the key bolt was not sufficiently loosened in Step 1 above, it may not be possible to pass the

stopper over the cymbal holder’s shaft. In such a case, loosen the key bolt as much as possi-

ble without removing it.

4Replace the bolt cover. (See Figure 3.)

• When assembling the bolt cover, turn until it no longer rotates.

5Secure the stopper in place. With the stopper making full contact with the bottom surface of the bolt

cover, tighten the stopper’s key bolt using a tuning key. (See Figure 4.)

Setting Up

• If the clamp bolt and other fasteners are not sufficiently tightened, your pad unit may fall,

possibly causing injury. It is important, therefore, that you mount your pad unit securely on

the drum rack or stand. In addition, you should avoid placing your rack or stand on an

uneven surface as this may cause it to fall over while being played, again increasing the risk

of injury.

Key bolt

Stopper Stopper

Tuning key

(optional)

[Figure 1] [Figure 2] [Figure 3]

Bolt cover

Cymbal

holder

Bolt cover

Cymbal

holder

Wing nut

Felt Pads

Stopper

[Figure 4]

Bolt cover

Full contact

pcy100_135_155_en_om.fm Page 6 Tuesday, November 9, 2010 4:07 PM