Yamaha PCY100 Pads & Trigger Input Jacks

6Place one of the felt pads removed in Step 2 on the cymbal holder. (See Figure 5.)

7Mount the pad unit on the cymbal stand. Lower the pad unit into place with the cymbal holder’s

shaft passing through the central hole of the Cup section. When mounted, the stopper’s pin should

rest inside the pad unit’s smaller hole. (See Figure 5.)

• If you were to play your pad unit without the stopper’s pin positioned fully inside the smaller

hole, it could slip out of the hole as you play.

8Assemble the felt pad that came with your pad unit. (See Figure 5.)

• The second felt pad removed from the cymbal holder in Step 2 above is not required for

assembly of your pad unit.

9Tighten the wing nut to secure the pad unit to the cymbal holder. (See Figure 5.)

The function of the PCY series pads varies according to which trigger input jack on the DTX Series

Drum Trigger Module the pad is connected.

Refer to the following website for its function in relation to trigger input jacks.

http://dtxdrums.yamaha.com/support/pad_compatibility/

Pads & Trigger Input Jacks

Cymbal holder

Bolt cover

Wing nut

Felt Pad

Felt pad that came

with pad unit

Stopper

[Figure 5]

Pad unit Pad unit Cup

Cup

Stopper’s

pin Smaller

hole

pcy100_135_155_en_om.fm Page 7 Thursday, November 11, 2010 5:07 PM