Connect the SPEAKERS terminals to your speakers with wire | How to Connect: |
of the proper gauge, cut to be as short as possible. If the |
|
connections are faulty, no sound will be heard from the | Red: positive (+) |
speakers. Make sure that the polarity of the speaker wires is | Black: negative |
correct, that is, + and – markings are observed. If these wires |
|
are reversed, the sound will be unnatural and will lack bass. |
|
Do not let the bare speaker wires touch each other and do not let them touch the metal parts of this unit as this could damage this unit and/or speakers.
●One or two speaker systems can be connected to this unit. If you connect only one speaker system, connect it to either the SPEAKERS A or B terminals.
●Use speakers with the specified impedance shown on the rear of this unit.
➀ | ➀Press up the tab. | |
| ||
| ➁Insert the bare wire. | |
➂ | [Remove approx. 5mm | |
(1/4”) insulation from | ||
| ||
| the speaker wires.] | |
➁ | ➂Press down the tab and | |
| secure the wire. |
(Europe model) ................................... | 2 SWITCHED OUTLETS |
(U.K. model) .......................................... | 1 SWITCHED OUTLET |
Use these to connect the power cords from your components to this unit.
The power to the SWITCHED outlets is controlled by this unit’s POWER switch or the provided remote control transmitter’s POWER key. These outlets will supply power to any component whenever this unit is turned on.
The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLET(S) is 100 watts.
If you have a YAMAHA turntable with a terminal for remote control, connect it to this connector by using the cable provided with the turntable. This connection allows you to control the turntable from the provided remote control transmitter.
GND terminal (For turntable use)Connecting the ground wire of the turntable to this terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected.
8