Yamaha RL RX-E100, RX-E100 MIN, AUX, AUX, AUX, BASS, INPUT, POWER, POWER, INPUT, INPUT, BASS:, POWER, TUNER, PHONES, VOLUME, VOLUME, TREBLE, PHONES, BALANCE, BALANCE, TREBLE:, STANDBY

RX-E100 BASIC OPERATIONS

Listening to a source

PHONES		TREBLE		VOLUME
NATURAL SOUND STEREO RECEIVER RX-E100
					VOLUME
TIMER
STANTBY
DISPLAY MEMORY	AUTO/MAN'L PRESET/BAND		PRESET/TUNING
					MINMAX
TIME ADJ	TIMER	HOUR		MIN	INPUT
STANDBY/ON PHONES		BASS	TREBLE	BALANCE
	-	+	- +	L R
STANDBY/ON	BASS		BALANCE		INPUT

SLEEPDISP

TIME

AC

REPPROG

B

RNDM

DE

PEAKTAPE

POWER

	VOLUME
	TAPE	VOLUME –/+
MD	AUX CD
	TUNER
	PRESET
MD REC	TAPE REC
	TAPE

MODESTART

DUBBING

1Set the volume to “ MIN” by turning VOLUME.

2Turn on the power by pressing STANDBY/ON on the front panel, or POWER on the remote control.

•RX-E100 can be used to turn on or put in standby mode the system connected E100 series components depending on their prior standby/on status.

3Select the desired input source by turning INPUT so that the source appears on the display.

•When you operate the component connected to the AUX terminal, turn INPUT to select AUX.

4Play the source. (Refer to the owner’s manual supplied with each selected component.)

5Adjust the volume level by turning VOLUME on the front panel or pressing VOLUME + on the remote control.

6If desired, adjust BASS, TREBLE, and BALANCE.

BASS: Turn this control clockwise to increase (or counterclockwise to decrease) the low frequency response.

TREBLE: Turn this control clockwise to increase (or counterclockwise to decrease) the high frequency response.

BALANCE: Adjust the balance of the output volume from the left and right speakers to compensate for sound imbalance caused by the speaker location or listening room conditions

•These controls are only effective for the sound from the main speakers.

When you use headphones

Connect the headphones to the PHONES jack. You can listen to the sound from the main speakers through the headphones.

When you have finished using this unit

Press STANDBY/ON on the front panel again or POWER on the remote control to set this unit to the standby mode.

• The STANDBY indicator lights up.

Auto power off function

RX-E100 will be put automatically into the standby mode under the following conditions:

•The component connected to RX-E100 is in stop mode and not operated for 30 minutes.

•TUNER or AUX is not selected as an input source.

E-8