Yamaha RX-V480 CONNECTING SPEAKERS, ABOUT THE ACCESSORY TERMINALS

CONNECTING SPEAKERS

	Rear speakers	Front speakers A
Right	Left
	Right	Left

SPEAKERS
REAR
L
CENTER
R	SPEAKERS
REAR
R	L

TAPE	IN	VCR
REC	IN	OUT
OUT

		Right		Left
	Center speaker
		Front	speakers B
Connect the SPEAKERS terminals to your speakers with wire		How to Connect:
of the proper gauge, cut to be as short as possible. If the
connections are faulty, no sound will be heard from the		Red: positive (+)
speakers. Make sure that the polarity of the speaker wires is		Black: negative (–)
correct, that is, + and – markings are observed. If these wires
are reversed, the sound will be unnatural and will lack bass.
Do not let the bare speaker wires touch each other and do		➀
not let them touch the metal parts of this unit as this could		➀		➀Press up the tab.
				➀Press up the tab.
damage this unit and/or speakers.				➁Insert the bare wire.
●	Use speakers with the specified impedance shown on the	➂		[Remove approx. 5mm
	rear of this unit.	➂		(1/4”) insulation from
	rear of this unit.			(1/4”) insulation from
●	Note for front speaker connection:			the speaker wires.]
	One or two speaker systems can be connected to this unit.		➁	➂Press down the tab and
	If you connect only one speaker system, connect it to either		➁	secure the wire.
				secure the wire.

the SPEAKERS A or B terminals.

ABOUT THE ACCESSORY TERMINALS

AC OUTLET(S)

(U.S.A., Canada, Europe and General models)

............................................................2 SWITCHED OUTLETS

(Australia and U.K. models)

.............................................................. 1 SWITCHED OUTLET

Use these to connect the power cords from your components to this unit.

The power to the SWITCHED outlets is controlled by this unit’s POWER switch or the provided remote-control transmitter’s POWER key. These outlets will supply power to any

8 component whenever this unit is turned on.

The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLET(S) is 100 watts.

GND terminal (For turntable use)

Connecting the ground wire of the turntable to this terminal will minimize hum, but in some cases better results may be obtained with the ground wire disconnected.