EPTY SEEK MODE button

When this button is pressed, the unit turns into the PTY SEEK mode.

FPTY SEEK START button

Press this button to begin searching for a station after the desired program type is selected in the PTY SEEK mode.

GEON button

Press this button to select a desired program type (NEWS, INFO, AFFAIRS, SPORT) when you want to call a radio program of that program type automatically.

HFM/AM button

Press this button to switch the reception band to FM or AM.

IMEMORY (MAN’L/AUTO FM) button

When this button is pressed, the “MEMORY” indicator flashes for about 5 seconds. During this period, select a desired preset station number by pressing the corresponding preset station number selector button to enter the displayed station into the memory.

When this button is pressed and held for more than 3 seconds, the automatic preset tuning begins. (For details, refer to page 31.)

JEDIT button

This button is used to exchange the places of two preset stations with each other.

KTUNING DOWN/UP button

Used for tuning. Press the “UP” side to tune in to higher frequencies, and press the “DOWN” side to tune in to lower frequencies.

When this unit is in the PTY SEEK mode, pressing this switch changes the currently selected program type.

LTUNING MODE (AUTO/MAN’L MONO) button Press this button to switch the tuning mode to automatic or manual. To select the automatic tuning mode, press this button so that the “AUTO” indicator lights up on the display. To select the manual tuning mode, press this button so that the “AUTO” indicator goes off.

MDELAY/CENTER/REAR/SWFR and TIME/LEVEL +/– buttons

RX-V493RDS only

Adjust the delay time (DELAY), the center channel output level (CENTER), the rear channel output level (REAR) and the output level to the SUBWOOFER OUTPUT terminal (SWFR). Select the item which you want to adjust by pressing the DELAY/CENTER/REAR/SWFR button and adjust its time or level by pressing the TIME/LEVEL +/– button.

NCENTER MODE button

Selects a center channel output mode (NORMAL, WIDE or PHANTOM). (For details, refer to page 23.)

OPROGRAM selector button RX-V393RDS only

When the built-in digital sound field processor (including the Dolby Pro Logic Surround decoder) is on, this button changes the currently selected DSP program whenever the right or left side of this button is pressed.

PCENTER LEVEL control RX-V393RDS only

Adjusts the sound output level of the center speaker.

QREAR LEVEL control RX-V393RDS only

Adjusts the sound output level of the rear speakers.

18