CONNECTIONS

Connecting the antennas RX-V630RDS

Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength.

Connect each antenna correctly to the designated terminals.

AM loop antenna

(included)Indoor FM antenna

(included)

■Connecting the AM loop antenna

1 Set up the AM loop antenna, then connect it.

O

VIDEO

TUNER

AM

ANT

GND

DVD

75 UNBAL. D-TV

/CBL

FM

ANT

MONIT

OUT

VIDEO

R OUT

Ground (GND terminal)

For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.

2 Press and hold the tab to insert the AM loop

antenna lead wires into the AM ANT and GND terminals.

3 Orient the AM loop antenna for the best reception.

PREPARATION

75-ohm/300-ohm antenna adapter (U.K. model)

1

2

 

 

 

11

(7/16)

 

 

8

(5/16)

Unit:

 

6

(1/14)

mm (inch)

Open the cover of the

Cut the external sleeve

included 75-ohm/300-ohm

of the 75-ohm coaxial

antenna adapter.

cable and prepare it for

 

connection.

 

3

Lead wire

Cut the lead wire and remove it.

Notes

•The AM loop antenna should be placed away from this unit.

•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.

A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about the outdoor antennas.

4

Clamp

Clamp with

with

pliers.

pliers.

 

 

Insert the wire

 

into the slot.

Insert the cable wire into the slot, and clamp it with pliers.

5

Snap the cover into place.

English

17