Yamaha RX-V670 To record a source to tape, DSP, PHONO, Notes, VOLUME, VCR 1 MON, VCR 1 MON, VCR 1 MON, TAPE 1 MON, TAPE 1 MON, TAPE 1 MON, LD/TV, TUNER, VCR 2/TAPE 2 MON

1, 4 2

To record a source to tape

1 Select the source to be recorded.

*To dub from tape to tape, refer to the “Notes” shown below.

*When selecting LD/TV, TUNER, CD or PHONO, make sure that the TAPE 1 MON, VCR 1 MON or VCR 2/TAPE 2 MON input selector(s) are not also selected.

2 Play the source and then turn the VOLUME control up to confirm the input source.

3 Set the tape deck or VCR to the recording mode.

4 To monitor the audio and/or video signals being recorded, press the input selector button for the audio or video tape recorder being used to make the recording.

*A red selector switch indicator takes priority over an orange indicator.

Notes

●There are three ways to dub from tape to tape:

1)To record from VCR 2 or tapedeck 2 to VCR 1, press both the VCR 2 MON/TAPE 2 MON and VCR 1 MON selector switches (so both the indicators are lighted red).

2)To record from VCR 2 or tapedeck 2 to tapedeck 1, press both the VCR 2 MON/TAPE 2 MON and TAPE 1 MON selector switches (so both the indicators are lighted red).

3)To record from VCR 1 to tapedeck 1, press both the VCR 1 MON and TAPE 1 MON selector switches (so both the indicators are lighted red).

●DSP, VOLUME, BASS, TREBLE and BALANCE control settings have no effect on the material being recorded.

14