ON-SCREEN DISPLAY (OSD)
You can display operational information for this unit on a video monitor. If you display the SET MENU and DSP program parameter settings on a monitor, it is much easier to see the available options and parameters than it is by reading this information on the front panel display.
y
•If a video source is playing, the OSD is superimposed over the video image.
•The OSD signal is not output to the OUT (REC) jack, and will not be recorded with any video signal.
•You can set the OSD to turn on (blue background) or off when there is no video signal by using “10 DISPLAY SET” on the SET MENU (see page 46).
OSD modes
You can select the amount of information the shown in the
This mode shows the DSP program parameter settings continuously on the video monitor.
Short displayThis mode briefly shows the front panel display message at the bottom of the screen and then disappears.
Display offThis mode briefly shows “DISPLAY OFF” at the bottom of the screen and then disappears. In this mode, no operational information will be shown on the monitor, except when ON SCREEN is pressed.
P01 CONCERT HALL
I N I T . D L Y … … … … 4 5 m s
R O O M S I Z E … … … … 1 . O
L I V E N E S S … … … … … … … 5
P 0 1 C O N C E R T H A L L
Full display | Short display |
y
•When you choose the full display mode, INPUT l/ h, VOLUME and some other types of operational information are displayed at the bottom of the screen in the same format as the front panel display.
•The SET MENU and test tone display appear regardless of the OSD mode.
Selecting the OSD mode
|
|
| SELECT |
|
POWER |
| POWER | AMP | 2 |
TV |
| AV |
| |
REC |
|
|
|
|
|
| AUDIO | + |
|
DISC SKIP |
|
|
| |
|
|
| VOL |
|
|
|
| – |
|
LEVEL | + | SET MENU | MUTE |
|
TITLE | MENU |
|
| |
TV INPUT | TV VOL | A/B/C/D/E |
|
|
|
|
| ||
CH | TV MUTE | CH |
| 3 |
– | SELECT | + |
| |
PRESET |
| PRESET |
| |
TEST | TV VOL | ON SCREEN | STEREO | |
RETURN | – | DISPLAY |
|
|
EFFECT
1 Turn on the video monitor connected to this unit.2 Press AMP.3 Press ON SCREEN on the remote control repeatedly to change the display mode.The OSD mode changes in the following order: full display, short display, and display off.
Notes
•If your video monitor is connected only to the COMPONENT VIDEO jacks of this unit, the OSD is not shown. Make sure to connect your video monitor to the COMPONENT VIDEO jacks and either VIDEO or S VIDEO jacks if you want to see the OSD.
•Playing back video software that has an
(When using two video monitors)
•If you select video source from a component connected to both the S VIDEO IN and composite VIDEO IN jacks, and both S VIDEO OUT and composite VIDEO OUT jacks are connected to two different monitors, the OSD appears only the monitor connected with
20