Yamaha RX-V795RDS mIMPEDANCE SELECTOR switch

Note on main speaker connections:

One or two speaker systems can be connected to this unit. If you use only one speaker system, connect it to either the SPEAKERS A or B terminals.

Note on a subwoofer connection:

You may wish to add a subwoofer to reinforce low frequencies or to output low bass sound from the subwoofer channel when reproducing discrete signals.

When using a subwoofer, connect the SUBWOOFER terminal of this unit to the INPUT terminal of the subwoofer amplifier, and connect the speaker terminals of the subwoofer amplifier to the subwoofer.

With some subwoofers, including the Yamaha Active Servo Processing Subwoofer System, the amplifier and subwoofer are in the same unit. Such a subwoofer needs only the connection between the SUBWOOFER terminal of this unit and the INPUT terminal of the subwoofer.

(Refer to page 22 for details about the SUBWOOFER terminal.)

PREPARATION

English

mIMPEDANCE SELECTOR switch

WARNING

Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.

IF THIS UNIT FAILS TO TURN ON WHEN THE STANDBY/ON SWITCH IS PRESSED:

The IMPEDANCE SELECTOR switch may not be set to either end. If so, set the switch to either end when this unit is in the standby mode.

IMPEDANCE SELECTOR

IMPEDANCE SELECTOR

REAR	SET BEFORE POWER ON
	REAR		: 6ΩMIN. /SPEAKER
(SURROUND)
	CENTER		: 6ΩMIN. /SPEAKER
	MAIN	A OR B: 4ΩMIN. /SPEAKER
		A	B: 8ΩMIN. /SPEAKER
	REAR		: 8ΩMIN. /SPEAKER
	CENTER		: 8ΩMIN. /SPEAKER
	MAIN	A OR B: 8ΩMIN. /SPEAKER
		A	B:I6ΩMIN. /SPEAKER

AC OUTLETS

SWITCHED

I00W MAX. TOTAL

(Europe model)

Select the position whose requirements your speaker system meets.

(Upper position)

Rear: The impedance of each speaker must be 6Ω or higher.

Center: The impedance of the speaker must be 6Ω or higher.

Main: If you use one pair of main speakers, the impedance of each speaker must be 4Ω or higher.

If you use two pairs of main speakers, the impedance of each speaker must be 8Ω or higher.

(Lower position)

Rear: The impedance of each speaker must be 8Ω or higher.

Center: The impedance of the speaker must be 8Ω or higher.

Main: If you use one pair of main speakers, the impedance of each speaker must be 8Ω or higher.

If you use two pairs of main speakers, the impedance of each speaker must be 16Ω or higher.

21