CONNECTIONS

Connecting the Speakers

Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass.

CAUTION

•Use speakers with the specified impedance shown on the rear panel of this unit.

•Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage the unit and/or speakers.

If necessary, use the SET MENU to change the speaker mode settings according to the number and size of the speakers in your configuration after you finish connecting your speakers.

■Speaker cables

 

 

 

 

 

 

 

 

 

A speaker cord is actually a pair of insulated cables

 

 

 

 

 

 

 

 

 

running side by side. One of the cables is colored or

10 mm (3/8”)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

shaped differently, perhaps with a stripe, groove or ridge.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1 Remove approx. 10 mm (3/8”) of insulation

1

 

 

2

 

 

 

 

 

 

 

 

from each of the speaker cables.

 

 

 

 

 

 

 

 

 

2 Twist the exposed wires of the cable

 

 

 

 

 

 

 

 

 

together to prevent short circuits.
■Connecting to the SPEAKERS terminals

Red: positive (+)

 

1 Unscrew the knob.

2

2 Insert one bare wire into the hole in the side

Black: negative (–)

 

1

of each terminal.

 

 

3 Tighten the knob to secure the wire.

 

3

 

■MAIN SPEAKERS terminals

One or two speaker systems can be connected to these terminals. If you use only one speaker system, connect it to either of the MAIN A or B terminals.

■REAR SPEAKERS terminals

A rear speaker system can be connected to these terminals.

■CENTER SPEAKER terminals

A center speaker can be connected to these terminals.

16