Remote control
TEST

SPEAKER BALANCE ADJUSTMENT

This operation uses an internal test-tone generator for balancing the levels of the main, center and rear speakers.

The adjustment of each speaker output level should be done at your listening position with the remote control unit. Otherwise, the result may not be satisfactory.

NOTE: Be sure to use the remote control unit with the lid open.

1.Set the TIME/LEVEL·SET MENU switch on the remote control to the TIME/LEVEL position.

Remote control

TIME/LEVEL

SET MENU

2. Depress the TEST key on the remote control so that “TEST DOLBY SUR.” appears on the display panel to enter test mode. A hiss-like calibration signal should be heard from the left main speaker, center speaker(s), right main speaker, right rear speaker and left rear speaker in turn (see diagram). Adjust the master VOLUME to a normal listening level.

*The state of test-tone output is shown on the display panel and the monitor screen. (On the monitor screen, it is shown by an image of audio listening room.) This is convenient for adjusting each speaker level.

 

Left main

 

Center

 

 

 

 

 

Right main

 

 

 

 

 

 

 

 

 

 

 

 

 

 

LEFT

 

 

 

 

CENTER

 

 

 

 

 

RIGHT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Left rear

 

 

 

Right rear

 

 

 

 

 

 

 

 

 

 

 

 

LEFT

 

 

 

 

RIGHT

 

 

 

 

 

 

 

 

SURROUND

 

 

 

 

SURROUND

 

 

 

 

3. Press the

or

key to select the speaker whose level you will

adjust.

 

 

Remote control

 

 

 

 

 

 

 

 

 

 

 

 

 

 

*Whenever the key is pressed, the speaker selection changes in turn as follows.

Center

 

 

Right rear

CENTER

 

 

R SUR.

 

 

L SUR.

Left rear

Pressing the key changes the speaker in the reverse order.

*If the CENTER SPEAKER mode is set to “PHNTM” (phantom), “CENTER” cannot be selected. (See page 35.)

4.Adjust the level of the speaker selected in step 3 by pressing the + or – key so that it becomes almost as same as that of the main speakers.

*While adjusting, the test-tone is fixed on the selected speaker.

Remote control

5. Repeat step 3 and 4 to adjust the level of other speakers.

40