Yamaha SLB-100 owner manual Attaching the Frame Unit

■Attaching the Frame Unit

The Silent Bass is shipped from the factory with the Frame Unit removed from the main body.

Please properly attach the Frame Unit using the following procedure.

1 Open the frame unit’s armrest until it comes in contact with the stopper.

2 Fully loosen the [Fixing Knob 2] located on the bottom end of the main body.

3 Align the cut end of the Frame Unit with the post above the [Fixing Knob 2] and fully insert. Then, align the notch at the top of the Frame Unit so it rests on the top of the bass’ main body and slowly insert.

4 Turn the [Fixing Knob 1] located on the upper portion of the frame unit clockwise until it is tight, to attach the frame unit to the body.

3

1

Fixing Knob 1

4 Tighten

5 Turn the [Fixing Knob 2] on the bottom end of the main body clockwise (looking from the bottom) until it is tight, to attach the frame unit to the body.

6 Align the [Fixing Knob 3], located on the center of the frame unit, with the Fixing Knob Plate located on the center of the main body, then turn clockwise to tighten.

When you move the frame unit’s center section, be careful not to pinch your fingers, hand, etc.

Fixing Knob 3

6 Tighten

3

2 Loosen

Fixing Nut 2

5 Tighten

This completes attachment of the frame unit.

To remove the frame, simply reverse the order of the previous procedure.

•Make sure that Fixing Knobs 1-3 are tightened firmly. If they are left loose, it may result in rattle or noise during performance.

•When transporting the instrument, always hold it by its neck or main body. Holding by the frame unit only may result in damage to the frame unit.

9