CONTROLS AND FUNCTIONS
Wireless transmitter unit (TRX-1T)
1
2
1Antenna
Adjust the antenna direction for best signal transmission.
2POWER indicator
Lights red when you connect the AC adaptor to the DC IN jack on this unit and to an AC outlet. If the unit does not receive a signal from the amplifier within 5 minutes after connection to the AC outlet, it places itself in standby mode and the power indicator goes out. The unit turns on again when it receives a signal from the amplifier.
5
4
3
3 Speaker terminal cable
Connect to the surround speaker jack on your amplifier.
4 CHANNEL SELECTOR switch
Set to the number selected on the channel selector of the wireless receiver unit (see page 5).
5 DC IN jack
Connect to the included AC adaptor.
Wireless receiver unit (TRX-1R)
The following figure depicts the unit with the cover removed.
5
1
2
4
3
1 AC power cable
Connect the plug to an AC outlet.
2 Surround speaker terminal
Connect the speaker cables to the surround sound speakers.
3 CHANNEL SELECTOR switch
Set to the number selected on the channel selector of the wireless transmitter unit (see page 5).
4Antenna
Adjust the antenna direction for best signal reception.
5POWER indicator
Lights red when you connect the AC power cable to an AC outlet. Lights green when the unit receiving a signal from wireless transmitter unit. When the signal from the wireless transmitter unit is cut, the unit places itself in standby mode, and the power indicator lights red.
2