You can also make use of an automatic preset tuning function for RDS stations only. By this function, this unit performs automatic tuning and stores RDS stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the manual preset tuning method on page 10.
|
|
|
|
|
|
| 2 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| PRESET STATIONS |
| TUNING | |
|
|
|
|
|
|
| MEMORY A/B/C/D/E | 1 | 2 | 3 | 4 | ||
POWER |
|
|
|
|
|
| MAN'L/AUTO FM |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| |
RDS MODE/FREQ | PTY SEEK | EON | FM/AM |
| TUNING MODE | EDIT | 5 | 6 | 7 | 8 | |||
|
|
|
|
|
|
| |||||||
|
| MODE START |
|
| AUTO/MAN'L MONO |
|
|
|
|
|
|
| |
PTY SELECTOR
English
1
To store stations
1 FM/AM
2 | MEMORY |
|
|
| |
| FM | Press and |
|
| hold for about |
|
| 3 seconds. |
AUTO STEREO
MHz 0 20 l00
MEMO PS PTY RT CT
Flashes.
The automatic preset tuning begins from A1. Received stations are programmed to A1, A2 ... A8 sequentially.
*If more than 8 stations are received, they are also programmed to the preset station numbers on other groups (B, C, D and E) in that order.
When the automatic preset tuning is finished
The display shows the frequency of the last preset station. Check the contents and the number of preset stations by following the procedure of the section “To recall a preset station” on page 10.
To recall a preset station
Simply follow the procedure of the section “To recall a preset station” on page 10. A recalled station is shown by the frequency or station name on the display.
Notes
●The automatic preset tuning search is performed through all RDS network frequencies until stations are stored up to E8. If the number of received stations is not enough to be stored up to E8, the search will be finished automatically after searching all frequencies.
●With this function, only RDS stations with sufficient signal strength are stored automatically. If the station you want to program is weak in signal strength, tune to it in monaural manually and program it by following the procedure of the section “To store stations” on page 10.
*There may be a case that this function cannot receive a station which could be received by the automatic tuning method. This is because this function receives a large volume of PI (Program Identification) data along with the station.
●If no station is received by the automatic preset tuning search, the search finishes after “NOTHING” flashes for about 3 seconds on the display.
●You can replace a preset station by another FM or AM station manually by simply following the procedure of the section “To store stations” on page 10.
11