Soloing AUX Sends using the [AUX 1]–[AUX 8] Buttons 107
DM1000 Version 2—Owner’s Manual
8
Aux Sends
Soloing AUX Sends using the [AUX 1]–[AUX 8] Buttons
You can turn the Solo function on and off using the AUX SELECT [AUX 1]–[AUX 8] but-
tons, without having to switch to the Master layer. This is convenient when you wish to con-
trol the Solo function for Aux Out 1-8 while adjusting the Aux Sends from Input Channels.
1 Press the MONITOR [DISPLAY] button repeatedly until the Monitor | Solo
page appears.
2 Make sure that the SOLO parameter is set to Enabled.
3Move the cursor to the AUX/SOLO LINK check box, then press the [ENTER]
button.
A pop-up window appears, asking you to confirm the setting.
4To check the AUX/SOLO LINK check box, move the cursor to the YES button,
then press the [ENTER] button.
5Press the desired AUX SELECT [AUX 1]–[AUX 8] buttons (for the Aux Sends
that you wish to solo) to light up the button indicators, then press the same
buttons again.
Only the selected Aux Sends are soloed, and the corresponding [AUX 1]–[AUX 8] buttons
flash.