Yamaha 006IPTO-F0, WD83390

Editing Effects 159

DM1000 Version 2—Owner’s Manual

Internal Effects

Editing Effects

To edit effect programs recalled to the internal Effects processors 1–4, press the DISPLAY

ACCESS [EFFECT] button repeatedly until the Edit page for the effects processor you wish

to edit appears.

Effects processors 1–4 correspond to the following pages:

•Effects Processor 1.......FX1 Edit page

•Effects Processor 2.......FX2 Edit page

•Effects Processor 3.......FX3 Edit page

•Effects Processor 4.......FX4 Edit page

These Edit pages contain the following effect parameters.

AEFFECT NAME

This parameter displays the name of the effect program currently used by the effects

processor.

BTYPE

This parameter displays the type of effect program currently used by the effects proces-

sor. The I/O conﬁguration of the effect program is displayed below this parameter.

Cbutton

Move the cursor to this parameter, then press [ENTER] to display the Library page for

the selected effects processor.

Dbutton

Move the cursor to this button, then press [ENTER] to display the In Patch | Effect page,

which enables you to assign signals to the inputs and outputs of Effects processors 1–4.

EMIX BALANCE

This parameter knob enables you to set the balance between wet and dry signals. When

the parameter is set to 0%, only the dry signal is heard. When set to 100%, only the wet

signal is heard. Turn on the BYPASS button to bypass the currently-selected effects pro-

cessor.

FTEMPO

This section displays the parameters that appear only when a delay effect type or a mod-

ulation-based effect type is selected. These TEMPO parameters calculate and set the

delay time for delay effects, or the modulation frequency for modulation effects, relative

to the speciﬁed tempo and note length. Use these parameters along with the SYNC or

NOTE parameter located at the bottom of the display page.