52
Setup required when starting up
LS9-16/32 Owner’s Manual
4In the STEREO MASTER section of the top
panel, make sure that the STEREO channel
[ON] key is on, and raise the STEREO chan-
nel fader to 0 dB.
5Make sure that the ST button for each chan-
nel in the window is on (white characters on
a pink background).
The ST button is an on/off switch for the signal sent
from each channel to the STEREO bus. This is the
same function as the ST button in the SELECTED CH
VIEW screen.
6To adjust the pan (INPUT channel) or bal-
ance (ST IN channel) of the signal sent from
the input channel to the STEREO bus, move
the cursor to the PAN/BAL knob of the
desired channel in the window, and operate
the dial or the [DEC]/[INC] keys.
7In the channel module section or the ST IN
section, make sure that the [ON] key of the
channel you want to operate is turned on.
8Raise the fader/encoder of each channel to
obtain an appropriate volume.
9If you want to operate a channel that is not
currently shown in the popup window, use
the [SEL] key to select that channel, and
then make settings for it.
For example if INPUT channels 1–8 are shown in the
popup window, pressing the INPUT channel 9 [SEL]
key will change the popup window to INPUT channels
9–16. If you press a [SEL] key of the ST IN section,
the L/R channels of ST IN channels 1–4 will be dis-
played together.
• If you’ve turned on POPUP APPEARS WHEN PRESSING
KNOBS in the PREFERENCE popup window (
→
p. 194), you
can also access this popup window by pressing the
SELECTED CHANNEL section [PAN] encoder.
HINT