Yamaha 007POTO-G0, WH39070

Setup required when starting up

LS9-16/32 Owner’s Manual

Here we explain how to adjust the level of a signal sent

from a gain-adjusted input channel to the STEREO bus,

adjust its pan (INPUT channel) or balance (ST IN chan-

nel), and monitor it from external speakers connected to

the STEREO channel. The following procedure will let

you check whether the mic, instrument, and main speakers

are connected appropriately.

When setting the level or pan/balance of a signal being

sent to the STEREO bus, you can either use the

SELECTED CHANNEL section or the SELECTED CH

VIEW screen in the display to make settings for a single

channel at a time, or use the popup window to make set-

tings for eight channels at a time.

●Controlling the signal sent to the STE-

REO bus, one channel at a time

Here’s how to select the input channel that you want to

control, and use the top panel faders/encoders, the

SELECTED CHANNEL section, and the SELECTED CH

VIEW screen of the display to control the level and pan/

balance.

1Press the SELECTED CHANNEL section

[HOME] key.

The SELECTED CH VIEW screen will appear in the

display.

1ST button

BPAN/BAL knob

2Use the keys of the LAYER section and the

[SEL] keys of the channel module section

to select the channel for the INPUT jack you

want to control.

3Make sure that the ST button in the screen

is on (white characters on a pink back-

ground).

The ST button is an on/off switch for the signal sent

from that channel to the STEREO bus. If this is off

(gray characters on a black background), move the

cursor to ST button and press the [ENTER] key.

4In the STEREO MASTER section of the top

panel, make sure that the STEREO channel

[ON] key is on, and raise the STEREO chan-

nel fader to 0 dB.

1STEREO channel [ON] key

BSTEREO channel fader

5In the channel module section or the ST IN

section, make sure that the [ON] key of the

currently selected channel is turned on.

Sending an input channel signal to

the STEREO bus