49
Setup required when starting up
LS9-16/32 Owner’s Manual
4
Connections and setup
●Making HA settings for a group of eight
channels
Here’s how to access a popup window where you can
make HA settings for a group of eight channels.
1Make sure that a mic or instrument is con-
nected to the INPUT jack (→ p. 41).
2Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1HA popup button
BGAIN knob
3Use the keys of the LAYER section and the
[SEL] keys of the channel module section
to select the channel for the INPUT jack you
want to control.
4Move the cursor to the HA popup button or
GAIN knob in the SELECTED CH VIEW
screen, and press the [ENTER] key.
The HA/PATCH popup window will appear, allowing
you to adjust the HA gain, switch phantom power on/
off, and switch the phase in groups of eight channels.
This popup window shows the parameters for the eight
channels that include the channel you selected in step
2.
1+48V button
BGAIN knob
Cø (phase) button
5To adjust the HA gain, move the cursor to
the GAIN knob of the desired channel in the
window, and use the dial or the [DEC]/[INC]
keys.
The input level of the channel is shown by the level
meter located immediately to the right of the GAIN
knob in the screen.
6To turn on phantom power for each chan-
nel, move the cursor to the +48V button in
the HA field of the screen, and press the
[ENTER] key.
The +48V button will turn on (red), and phantom
power will be supplied to the corresponding INPUT
jack.
7To switch the phase of each channel
between normal and reverse phase, move
the cursor to the ø button in the HA field
and press the [ENTER] key.
The ø button will change from black to red, and the
phase of the corresponding channel will be reversed.
8If you want to operate the HA of a channel
that is not currently shown in the popup
window, use the [SEL] key to select that
channel, and then make settings for it.
For example if INPUT channels 1–8 are shown in the
popup window, pressing the INPUT channel 9 [SEL]
key will change the popup window to INPUT channels
9–16.
1 2
1
2
3
• If you’ve turned on POPUP APPEARS WHEN PRESSING
KNOBS in the PREFERENCE popup window (
→
p. 194), you
can also access this popup window by pressing the
SELECTED CHANNEL section [HA GAIN] encoder.
HINT
• The PAD will be internally switched on or off when the HA
gain is adjusted between -14 dB and -13 dB. Keep in mind
that noise may be generated if there is a difference between
the Hot and Cold output impedance of the external device
connected to the INPUT connector when using phantom
power.
NOTE
• If you want to use phantom power, you must first turn ON the
+48V MASTER ON/OFF button located in the SYSTEM
SETUP screen.
NOTE