E
5.If the “LOCK” mode was chosen previ- ously, choose the “START” mode before starting the engine. (See pages
NOTE:
●If the initial setting of the PADLOC has not been done, the “START” mode is auto- matically selected.
●If you have previously chosen “LOCK” mode, the engine will not start unless the correct code is entered. This selects the “START” mode.
6.While lightly squeezing the throttle lever, push the start switch (green button).
WARNING
On this watercraft, the engine is con- nected directly to the jet pump. Starting the engine immediately generates some thrust. Apply only enough throttle to keep the engine running.
7.Release the start switch as soon as the engine starts to run.
CAUTION:
●Never push the start switch while the engine is running.
●Do not operate the start switch for more than 5 seconds, otherwise the battery will be discharged and the engine will not start. Also, the starter motor may be damaged. If the engine does not start in 5 seconds, release the start switch, wait 15 seconds, and try again.
8.After the engine has warmed up, push the choke knob in to its original position.
NOTE:
If the choke knob is left pulled out, the engine will stall.
