Yamaha XP100SD, XP100T, XP120SD, XP120T Setting Up, Connections

 XP100T/100SD/120T

After setting up your rack system (Yamaha RS series, etc.)

or a standard tom stand (Yamaha WS series, etc.), attach

the pad as shown in the illustration. Insert the tom holder

(hexagonal bar) q on your rack or tom stand into the pad,

and firmly tighten the clamp bolt w to secure.

 XP100SD/120SD

Before set up, please prepare a snare stand e (Yamaha

SS652, etc.), and set the XP100SD/120SD onto the stand

as you would an acoustic snare drum.

Use the supplied stereo phone cable to connect the output jack on the XP series pad to the input jack on the DTX Series

drum Trigger Module. Insert the L-shaped connector into the output jack (OUTPUT) on the XP series pad.

Setting Up

• Make sure that the pad is securely attached to the rack or stand. If the bolt is not tightened securely, the pad may

slip or fall down, causing injury. Also, if the rack or stand is placed on an unstable surface, etc., the rack or

stand may fall over, resulting in injury.

Connections

OUTPUT

01_xp120sd_en_c0.fm Page 5 Friday, November 12, 2010 8:10 PM