PLACING THIS SYSTEM

■Attaching the center system to a wall

Installing the center system using the keyholes

You can attach the center system to a wall using commercially available screws (#8, Diameter: 7.5 mm or more (5/16” or more)).

When installing the center system on a wall, all installation work must be performed by a qualified contractor or dealer. The customer must never attempt to perform this installation work. Improper or inadequate installation could cause the center system to fall, resulting in personal injury.

1 Attach the supplied mounting template on a wall and mark the holes of the mounting template.

Tapes or thumbtacks

Mark

2 Remove the mounting template and then install the commercially available screws at the marks.

Diameter:

7.5 mm or more (#8, 5/16” or more)

4 to 6 mm (3/16” to 1/4”)

Installing the cables above the center system

To pass the cables upward, you need to attach the spacers to make room on the back of the center system.

In step 2 of the left column;

2-a: Attach the supplied spacers to the rear panel of the center system using the supplied double-sided tapes. You can choose either the side A or the side B.

A: For narrow space

B: For wide space

Double-sidedDouble-sided

tapetape

AttachAttach

PREPARATION

y

 

 

To install the cables above the center system, refer to the right

 

 

column.

2-b: Remove the mounting template and then install

3 Hang the center system on the screws using

the commercially available screws at the marks.

 

 

the keyholes on the back of the center

 

 

system.

 

 

 

22 to 24 mm

34 to 36 mm

 

(7/8” to 15/16”)

(1-5/16” to 1-7/16”)

English

9 En