PLACING THIS SYSTEM

Installing the center system using the screw holes

You can also use the inner or outer screw holes on the rear of the center system for installing the center system using a commercially available bracket or rack.

 

 

Bracket or rack, etc.,

77 mm (3”)

550 mm (21-5/8”)

15 mm (9/16”)

 

290 mm

 

 

 

 

(11-7/16”)

Screw

 

 

 

 

(M6)

 

 

Screw hole

52.5 mm (2-1/16”)

Min 7 mm (1/4”)

 

 

 

Screw holes

 

 

Hole depth: 15 mm (9/16”)

 

 

Diameter: 6 mm (1/4”)

 

 

Inner pitch: 290 mm (11-7/16”)

 

 

Outer pitch: 550 mm (21-5/8”)

 

YAS-71CU

Notes

•The center system weighs about 5 kg (11 lbs.). Attach the center system to a bracket, rack or wall. Do not attach the center system to a wall that is made of weak materials such as plaster or veneered woods. Doing so may cause the center system to fall.

•Use commercially available screws that can support the weight of the installation.

•Make sure you use specified screws to attach the center system. Using clamps other than specified screws, such as short screws, nails, or two-sided tape, may cause the center system to fall.

•When connecting the center system, fix the speaker cables in place where they will not become loose. If your foot or hand accidentally gets caught on a loose speaker cable, the center system may fall.

•After attaching the center system, check that the center system is fixed securely. Yamaha will bear no responsibility for any accidents caused by improper installations.

10 En