Yamaha YDP-121 Keyboard Stand Assembly

YDP-121

Keyboard Stand Assembly

CAUTION

• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given

below.

• Assembly should be carried out by at least two persons.

• Be sure to use the correct screw size, as indicated above. Use of incorrect screws can cause damage.

• Be sure to tighten up all screws upon completing assembly of each unit.

• To disassemble, reverse the assembly sequence given below.

ZOpen the box and remove all the parts.

On opening the box you should find the parts shown in the illustration above. Check to make sure that all the required parts

are provided.

• Bundled pedal cord inside

• 6 x 35 mm round-head screws x 4 1

● Cord holders x 2 ● AC power cord

106

• 4 x 10 mm round-head screws x 2 2

• 4 x 16 mm tapping screws x 4 3

•6 x 16 mm flat-head screws x 4 4

Contents

Main IMPORTANT SPECIAL MESSAGE SECTION CAUTION PRECAUTIONS PLEASE READ CAREFULLY BEFORE PROCEEDING * Please keep these precautions in a safe place for future reference. WARNING CAUTION Introduction Included Accessories Contents The Dual Mode Reverb The Pedals Touch Sensitivity Transposition Tuning The Control Panel The Control Panel 1 890!@ # $ To open the key cover: To close the key cover: Key Cover & Music Stand To raise the music stand: To lower the music stand: Key Cover Music Stand Selecting & Playing Voices Turn Power On Playing the Demonstration Tunes Engage the Demo Mode Play a Voice Demo Voice Demo Exit From the Demo Mode Engage the Piano Song Mode Play a Piano Song Piano Song Exit From the Piano Song Mode Piano Song A-B Repeat Specify the Beginning (A) of the Phrase Specify the End (B) of the Phrase Stop Playback Piano Song Part Cancel Turn the Desired Part Off Start/Stop Playback Synchro Start Left Pedal Start/Stop The Dual Mode Other Dual Mode Functions Reverb Adjusting Reverb Depth The Pedals Soft (Left) Pedal Sostenuto (Center) Pedal Damper (Right) Pedal Touch Sensitivity Transposition Tuning Tuning Up Z X C Tuning Down The Metronome & Tempo Control The Metronome Metronome Time Signature Metronome Volume Function Tempo Control Using the Recorder Recording Make All Necessary Initial Settings Engage the Record Ready Mode Select the Record T rack Using the Recorder Start Recording Stop Recording Erasing a Single T rack Changing the Initial Settings Playback Synchro Start Left Pedal Start/Stop Using the Recorder The Function Mode To Select a Function .............................................. X Z C F1 F2 F2.1: Scale F2.2: Base Note F3 F3.1: Dual Balance F3.2: Dual Detune F3.3: 1st V oice Octave Shift F3.4: 2nd V oice Octave Shift F3.5: Reset F5 F4 F6 F7 F7.2: Tuning F7.3: Pedal F7.1: Voice Factory Preset Recall Options Troubleshooting Voice Demo Tune Titles Demo Song List Function Factory Setting List Keyboard Stand Assembly Z X C V B B D N M < After completing the assembly, please check the following. 7 8 Page Specifications FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! 2. IMPORTANT: When connecting this product to accessories and/ 3. NOTE: IMPORTANT NOTICE FOR THE UNITED KINGDOM Connecting the Plug and Cord IMPORTANT SAFETY INSTRUCTIONS PLEASE KEEP THIS MANUAL CANADA U.S.A. MEXICO NORTH AMERICA CENTRAL & SOUTH AMERICA EUROPE AFRICA MIDDLE EAST ASIA http://www2.yamaha.co.jp/manual/english/