GEN

IMPORTANT INFORMATION INFO

EBS00016

LOCK WASHERS/PLATES AND COTTER

PINS

After removal, replace all lock washers/plates and cotter pins. After the bolt or nut has been tightened to specification, bend the lock tabs along a flat of the bolt or nut.

EBS00017

BEARINGS AND OIL SEALS

Install bearings and oil seals so that the manu- facturer’s marks or numbers are visible. When installing oil seals, lubricate the oil seal lips with a light coat of lithium-soap-based grease. Oil bearings liberally when installing, if appro- priate.

Oil seal

NOTICE

Do not spin the bearing with compressed air because this will damage the bearing surfaces.

Bearing

EBS00018

CIRCLIPS

Before reassembly, check all circlips carefully and replace damaged or distorted circlips. Always replace piston pin clips after one use. When installing a circlip , make sure the

sharp-edged corner

is positioned opposite

the thrust

that the circlip receives.

Shaft

 

 

1 - 3