Yamaha YST-M101 CONTROLS & CONNECTORS, SPECIFICATIONS, TROUBLESHOOTING, (See figure 2on page IV.), Cause, Noise, 2INPUT, Driver, Weight, Problem, speakers, What to Do

CONTROLS & CONNECTORS SPECIFICATIONS

(See figure 2on page IV.)

1DC IN connector

Connect the supplied AC adaptor to this connector.

2INPUT

Connect this 3.5 mm mini plug connector cable to the output terminal of a CD player, a personal computer, etc. which input an audio source to YST-M101.

3TO LEFT SPEAKER

Connect the RCA pin plug cable from the left speaker to this connector.

4Power indicator

Lights up when the power of YST-M101 is on.

5POWER/VOLUME control

Slowly turn the control clockwise. When it clicks, the power of YST-M101 turns on and the power indicator (4) lights up.

Turn the control clockwise furthermore to increase the volume level of the entire speaker system and counterclockwise to decrease the level.

To turn YST-M101 into the standby mode, turn the control fully counterclockwise until it clicks. The power indicator (4) will also go off.

6Headphones jack

When you listen with headphones, connect the headphones to the headphones jack. No sound is outputted from the speakers when headphones are connected to this jack.

Type .................................		Yamaha Active Servo Technology
Driver .....	6.5 cm (2-9/16”) cone, magnetically shielded type
Amplifier output
Speaker ..................		3 W + 3 W (1 kHz, 4Ω at T.H.D.=10%)
Headphones ...............		0.45 V (1 kHz, 30Ω, Input: 200 mV)
Input sensitivity ........................			200 mV (1 kHz, 4Ω at 3 W)
Input impedance .......................................................			25 kΩ
Frequency response		.................................	80 Hz to 20 kHz
Power supply (AC adaptor)
U.S.A. and Canada models ......................			AC 120 V, 60 Hz
U.K. and Europe models ...........................			AC 230 V, 50 Hz
Australia model .........................................			AC 240 V, 50 Hz
Dimensions (W X H X D)
.............................	76 (3”) 3 215 (8-1/2”) 3 136 (5-3/8”) mm
Weight
Right speaker ............................................			0.7 kg (1.5 lbs.)
Left speaker ...............................................			0.6 kg (1.3 lbs.)
Accessory ...................................................			AC adaptor 3 1

* Specifications are subject to change without notice.

TROUBLESHOOTING

Refer to the chart below when the speakers do not function properly. If the problem you are experiencing is not listed below or if the instructions given below do not help, disconnect the AC adaptor and contact your authorized YAMAHA dealer or service center.

Problem	Cause	What to Do
No sound comes from the	The AC adaptor is not properly plugged	Insert the AC adaptor firmly into the AC
speakers.	into the AC receptacle.	receptacle.
	The POWER/VOLUME control is set to	Turn on the power by turning the
	off.	POWER/VOLUME control clockwise.
		(The power indicator lights up.)
	Connections are faulty or incomplete.	Make the connections again.
	The volume setting is low.	Turn the POWER/VOLUME control
		clockwise to increase the volume.
	The level of the signal being inputted is	Turn up the volume on the connected
	too low.	component.
	Headphones are connected.	Disconnect the headphones.
Sound is distorted.	The level of the signal being inputted is	Turn down the volume on the connected
	too high.	component.
Noise.	Connections are faulty or incomplete.	Make the connections again.

E-2