CONTROLS & CONNECTORS
(See figure 2on page IV.)
1INPUT
Connect this 3.5 mm mini plug connector cable to the output terminal of a CD player, a personal computer, etc. which input an audio source to
2BASS control
Allows you to adjust the output level of low range sound from the subwoofer.
A typical (recommended) setting is the position between one o’clock and two o’clock.
Rotate the control clockwise to increase the level and counterclockwise to decrease the level.
3TO LEFT SPEAKER
Connect the RCA pin plug cable from the left satellite speaker to this connector.
4DC IN connector
Connect the supplied AC adaptor to this connector.
5TO RIGHT SPEAKER
Connect the 8-pin cable from the right satellite speaker to this connector.
6Power indicator
Lights up when the power of YST-MS201 is on.
7POWER/VOLUME control
Slowly turn the control clockwise. When it clicks, the
power of YST-MS201 turns on and the power indicator (6) lights up.
Turn the control clockwise furthermore to increase the volume level of the entire speaker system and counterclockwise to decrease the level.
To turn YST-MS201 into the standby mode, turn the
control fully counterclockwise until it clicks. The power indicator (6) will also go off.
SPECIFICATIONS | ||
Type ................................. | Yamaha Active Servo Technology | |
Driver |
|
|
Satellite ....................... | 8.5 | |
|
| magnetically shielded type |
Subwoofer |
|
|
................ 12 cm | ||
Amplifier Output |
|
|
Satellite ................... | 6 W + 6 W (1 kHz, 4Ω at T.H.D.=10%) | |
Subwoofer .................... | 18 W (100 Hz, 4Ω at T.H.D.=10%) | |
Input sensitivity ........................ | 200 mV (1 kHz, 4Ω at 6 W) | |
Input impedance ....................................................... | 20 kΩ | |
Frequency response | ................................. | 45 Hz to 20 kHz |
|
| (Satellite + Subwoofer) |
Power supply (AC adaptor) |
| |
U.S.A. and Canada models ...................... | AC 120 V, 60 Hz | |
U.K. and Europe models ........................... | AC 230 V, 50 Hz | |
Australia model ......................................... | AC 240 V, 50 Hz | |
Dimensions (W X H X D)
Satellite speakers
............ 70 (2-3/4”) 3 195 (7-11/16”) 3 145 (5-11/16”) mm
Subwoofer
................ 193 (7-5/8”) 3 207 (8-1/8”) 3 214 (8-7/16”) mm
Weight |
|
Satellite speakers | ............................ Right: 0.6 kg (1.3 lbs.) |
| Left: 0.5 kg (1.1 lbs.) |
Subwoofer ................................................. | 2.8 kg (6.2 lbs.) |
Accessory ................................... | AC adaptor |
* Specifications are subject to change without notice.
TROUBLESHOOTING
Refer to the chart below when the speakers do not function properly. If the problem you are experiencing is not listed below or if the instructions given below do not help, disconnect the AC adaptor and contact your authorized YAMAHA dealer or service center.
Problem | Cause | What to Do |
|
|
|
No sound comes from the speakers or | The AC adaptor is not properly plugged into | Insert the AC adaptor firmly into the AC |
subwoofer. | the AC receptacle. | receptacle. |
|
|
|
| The POWER/VOLUME control is set to off. | Turn on the power by turning the POWER/ |
|
| VOLUME control clockwise. (The power |
|
| indicator lights up.) |
|
|
|
| Connections are faulty or incomplete. | Make the connections again. |
|
|
|
| The volume setting is low. | Turn the POWER/VOLUME control clockwise |
|
| to increase the volume. |
|
|
|
| The level of the signal being inputted is too | Turn up the volume on the connected |
| low. | component. |
|
|
|
The bass sound cannot be heard. | The BASS control is set to minimum. | Turn the subwoofer BASS control clockwise |
|
| to increase the volume. |
|
|
|
Sound is distorted. | The level of the signal being inputted is too | Turn down the volume on the connected |
| high. | component. |
|
|
|
Noise. | Connections are faulty or incomplete. | Make the connections again. |
|
|
|