Controls & Connectors
Rear |
| Top |
|
1 | USB | VOLUME | 7 |
INPUT |
8
TO RIGHT | 1 | 2 | TO LEFT 0 |
| 10 | DC 15V |
SPEAKER | INPUT | INPUT | SPEAKER | BASS |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2 | 3 | 4 | 5 | 6 | |||||
|
|
| (Subwoofer) |
|
|
|
|
| (Right satellite speaker) |
1USB INPUT
Use the included USB cable to connect this port to the USB port on the computer.
2TO RIGHT SPEAKER
Connect the
3INPUT 1/2
You can input two audio sources to the speaker system from these input jacks. For example, you can connect the output of a
4TO LEFT SPEAKER
Connect the RCA pin plug cable from the left sat- ellite speaker to this connector.
5BASS control
Allows you to adjust the volume level of the sub- woofer.
A typical (recommended) setting is the position between one o’clock and two o’clock.
Rotating the control clockwise will increase the volume level, and rotating the control counter- clockwise will decrease the level.
6DC connector
Connect the included AC adaptor to this connector.
Press the (standby/on) button on the right satel- lite speaker to turn the power on or standby.
7VOLUME control
Allows you to adjust the volume level of the entire speaker system.
Rotating the control clockwise will increase the volume level, and rotating the control counter- clockwise will decrease the level.
8(standby/on) button/indicator
Press this button to turn on the power to the speaker system. Its indicator lights up. Press the button again to turn the speaker system to standby mode.
Before pressing this button, make sure that the VOLUME control setting is lowered. A small elec- trical current flows through the speaker system even if the standby/on button is turned off.