Cautions
Please read the following operating precautions before use:
•When disconnecting the power cord from an AC receptacle, hold and pull the plug, not the cord.
•If the YST-MSW10 is not going to be used for a while, disconnect it from the AC receptacle.
•Since this unit has a built-in power amplifier, heat will radiate from the rear panel. Therefore, place the unit at least 10 cm (4 inches) away from the wall. Also, do not position with the rear panel facing down on the floor or other surface.
•Always disconnect from the AC receptacle before making any connections.
•YST-MSW10 does not contain any user serviceable parts. Refer all servicing to your Yamaha dealer.
•Do not expose the YST-MSW10 to temperature extremes, direct sunlight, excessive dust, humidity, or vibration.
•Site the YST-MSW10 on a level, stable surface. Do not drop the YST-MSW10, apply excessive force to its controls, or put heavy items on top of it.
•If the YST-MSW10 should require cleaning, use a soft cloth. If necessary, a damp cloth.
•Do not to put some objects into it. If doing so, the sound will be unnatural or it may cause damage to the speaker and/or amplifier.
•To protect the YST-MSW10 speaker, avoid microphone feedback, continuous and excessive output from electronic musical instruments, excessive signal distortion,
•Although the YST-MSW10 is magnetically shielded, keep floppy disks and tapes away from it.
•The YST-MSW10 may cause picture distortion when sited close to a television or computer monitor. In this case, move it away a little.
Connections
Refer to page 1 for system connections.
Rear Panel (Refer to page 2)
1LINE 1 IN: This 3.5 mm stereo jack connection is for inputting line-level signals to the YST-MSW10.
2LINE 1 OUT: This connection can be used to feed the input signal to other equipment.
3LINE 2: These RCA-pin jacks are for inputting speaker level signals to the YST-MSW10. They can be connected directly to the speaker outputs of a stereo amplifier.
