CONTROLS AND THEIR FUNCTIONS
Front panel
SUBWOOFER SYSTEM
STANDBY/ON HIGH
1 2 3 4
| Rear panel | 7 8 9 | 0 | A |
POWER | VOLTAGE | BASS PHASE AUTO |
| OUTPUT |
| STANDBY | /MONO | TO SPEAKERS | |
| SELECTOR | |||
|
|
|
| |
| ON |
|
|
|
|
| MUSIC MOVIE REV NORM HIGH LOW OFF |
|
|
| OFF |
|
|
|
5 | 6 |
|
| FROM AMPLIFIER |
|
|
| INPUT | INPUT |
|
|
| 2 | 1 |
B
1Power indicator
Lights up while the subwoofer is turned on.
2STANDBY/ON button
Press this button to turn on the power. Press again to set the subwoofer in the standby mode.
*This button can be used only when the POWER (5) switch is set in the ON position.
Standby mode
The subwoofer is still using a small amount of power in this mode.
3HIGH CUT control
Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected by this control are all cut off (and no output).
*One graduation of this control represents 10 Hz.
| 90Hz |
80Hz | 100Hz |
70Hz | 110Hz |
60Hz | 120Hz |
50Hz | 130Hz |
40Hz | 140Hz |
4VOLUME control
Adjusts the volume level. Turn the control clockwise to increase the volume, and counterclockwise to decrease the volume.
5POWER switch
Normally, set this switch to the ON position to use the subwoofer. In this state, you can turn on the subwoofer or turn the subwoofer into the standby mode by pressing the STANDBY/ON (2) button. Set this switch to the OFF position to completely cut off the subwoofer’s power supply from the AC line.
6VOLTAGE SELECTOR switch
(China and General models only)
If the preset setting of the switch is incorrect, set the switch to the proper voltage (110V, 120V, 220V or 240V) of your area.
Consult your dealer if you are unsure of the correct setting.
WARNING
Be sure to unplug the subwoofer before setting the VOLTAGE SELECTOR switch correctly.