7PHASE switch

Normally this switch is to be set to the REV (reverse) position. However, according to your speaker systems or the listening condition, there may be a case when better sound quality is obtained by setting this switch to the NORM (normal) position. Select the better position by monitoring the sound.

8AUTO STANDBY (HIGH/LOW/OFF) switch

This switch is originally set to the OFF position. By setting this switch to the HIGH or LOW position, the subwoofer’s automatic power-switching function operates as described below. If you do not need this function, leave this switch in the OFF position.

*Make sure to change the setting of this switch only when the STANDBY/ON (2) button is in the OFF position.

9INPUT2 terminals

Used to input line level signals from the amplifier. (Refer to “CONNECTIONS” for details.)

0OUTPUT (TO SPEAKERS) terminals

Can be used for connecting to the main speakers. Signals are sent directly from the amplifier to the main speakers by way of these terminals.

(Refer to “CONNECTIONS” for details.)

AINPUT1 (FROM AMPLIFIER) terminals

Used to connect the subwoofer with the speaker terminals of the amplifier.

(Refer to “CONNECTIONS” for details.)

English

AUTOMATIC POWER-SWITCHING FUNCTION

When you play a source, the power of the subwoofer turns on automatically by sensing audio signals input to the subwoofer. On the other hand, the subwoofer automatically switches to the standby mode if the source being played is stopped or the input signal is cut off for a few minutes. This function operates by sensing a certain level of low frequency input signal. Its sensitivity is high in the HIGH position and low in the LOW position of the AUTO STANDBY switch. Set this switch to the position you prefer. In the HIGH position, the power will turn on even with a low level of input signal. But please be aware that the subwoofer may not switch to the standby mode when there is an extremely low input signal.

*The power might turn on unexpectedly by sensing noise from other appliances. If that occurs, set the AUTO STANDBY switch to the OFF or LOW position.

*The level of low frequency input signal differs with each source and among different parts within the same source. This means that the function may not operate properly on some sources.

*The level of low frequency input signal this function senses is about 100 Hz.

This function is available only when the power of the subwoofer is on (by setting the STANDBY/ON button to “ON”).

E-9