SECTION 7: SERVICING YOUR SNOW THROWER
WARNING: Before servicing, repairing, or inspecting, disengage all clutch levers and stop engine. Wait until all moving parts have come to a complete stop. Disconnect spark plug wire and ground it against the engine to prevent unintended starting.
Augers
The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. See Figure 16. If you hit a foreign object or ice jam, the snow thrower is designed so that the bolts may shear.
Shear Bolts
Figure 16
If the augers do not turn, check if the bolts have sheared. Two replacement shear bolts and hex lock nuts have been provided with the snow thrower. Refer to Loose Parts on page 5. For future use, order kit number
IMPORTANT: NEVER replace the auger shear bolts with standard hex bolts. Any damage to the auger gearbox or other components, as a result of doing so, will NOT be coved by your snow thrower’s warranty.
Shave Plate and Skid Shoes
•The shave plate and skid shoes on the bottom of the snow thrower are subject to wear. They should be checked periodically and replaced when necessary.
•To remove skid shoes, remove the four carriage bolts, belleville washers and hex nuts which attach them to the snow thrower. Reassemble new skid shoes with the hardware earlier removed. Make certain the skid shoes are adjusted to be level.
•To remove shave plate, remove the carriage bolts, belleville washers and hex nuts which attach it to the snow thrower housing. Reassemble new shave plate, making sure heads of the carriage bolts are to the inside of the housing. Tighten securely.
Belt Removal and Replacement
Auger Belts
•Remove the plastic belt cover on the front of the engine by removing the two
Belt
Cover
Screws
Figure 17
•Drain the gasoline from the snow thrower, or place a piece of plastic film under the gas cap.
•Tip the snow thrower up and forward so that it rests on its auger housing.
•Remove six
•Roll the front and rear auger belts off the engine pulley. See Figure 18.
| Wheel |
| Drive |
| Pulley |
Auger |
|
Drive | Wheel |
Pulley | Drive |
Idler | Belt |
| |
Pulley | Idler |
| Pulley |
| Auger |
| Drive |
| Belts |
Frame |
|
Figure 18
14