Drift Cutters (on models so equipped)
Drift cutters should be used when operating the snow thrower in heavy drift conditions.
On models so equipped, drift cutters are assembled to the auger housing inverted. Remove the carriage bolts by unthreading the hex nuts which secure them, and reinstall the drift cutters in their proper position before operating the snow thrower. See Figure 8 .
Drift |
Cutter |
Carriage Screws / |
Hex Nuts |
Figure 8
If your unit is not equipped with drift cutters, contact Customer Support as instructed on page 2 for information regarding price and availability.
Snow Thrower ModelDrift Cutter Kit:
All
SECTION 3: MAINTAINING YOUR SNOW THROWER
General Recommendations
•Always observe safety rules when performing any maintenance.
•The warranty on this snow thrower does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain the snow thrower as instructed in this manual.
•Some adjustments will have to be made periodically to maintain your unit properly.
•Periodically check all fasteners and make sure these are tight.
WARNING: Always stop engine and disconnect spark plug wire before performing any maintenance or adjustments. Always wear safety glasses during operation or while performing any adjustments or repairs.
Lubrication (See Figure 9)
•Drive Mechanism: Once a season or after every 25 hours of operation, remove rear frame cover and lubricate any chains, sprockets, gears, bearings, and shafts with engine oil or lubricant spray.
IMPORTANT: Avoid oil spillage on rubber friction wheel and aluminum drive plate.
•Gear Shaft: Once a season, lubricate the gear shaft with a penetrating oil, but not grease. Refer to Figure 21 on page 16.
•Gear Case: The gear case is lubricated with grease at the factory and does not require regular lubrication. However, if disassembled for any reason, lubricate with 2 ounces of Shell Alvania™ grease (part #
IMPORTANT: Do not overfill the gear case, since damage to the seals could result.
•Wheels: Once a season, remove the bolt from each wheel and take the wheel off the axle. Apply a multipurpose automotive grease on the axle shaft before putting back the wheels.
•Shift Rod: Use a grease or light oil to lubricate the rotating parts of the shift rod after 25 hours of operation.
•Pivot Points: All pivoting points on the snow thrower should be lubricated with a light oil once a season.
12
