NOTE: Split-Line™ can only be used with the inner reel containing the slotted holes. Single line can be used on either type of inner reel. Use Figure 15 to identify the inner reel you have.

NOTE: Always use the correct line length when installing trimming line on the unit. The line may not release properly if the line is too long.

Slotted Holes

For Use with

For Use with Split-Line

Single Line ONLY

or Single Line

 

FIGURE 15

Single Line Installation

6.Take approximately 7.6 m (25 feet) of new trimming line and loop it into two equal lengths. Insert each end of the line through one of the two holes in the inner reel, Figure 16. Pull the line through the inner reel so that the loop is as small as possible.

Loop

FIGURE 16

7.Wind the lines in tight even layers onto the reel, Figure 17. Wind the line in the direction indicated on the inner reel. Place your index finger between the two lines to stop the lines from overlapping. Do not overlap the ends of the line.

FIGURE 17

Split-Line™ Installation

8.Take approximately 3.65 m (12 feet) of new trimming line. Insert one end of the line through one of the two holes in the inner reel, Figure 18. Pull the line through the inner reel until only about 4 inches is left out.

9.Insert the end of the line into the open hole in the inner reel and pull the line tight to make the loop as small as possible, Figure 18.

Loop

FIGURE 18

10.Before winding, split the line back about 6 inches.

11.Wind the line in tight even layers in the direction indicated on the inner reel.

NOTE: Failure to wind the line in the direction indicated will cause the cutting attachment to operate incorrectly.

Holding Slots

FIGURE 19

12.Insert the ends of the line into the two holding slots, Figure 19.

13.Insert the ends of the line through the eyelets in the outer spool and place inner reel with spring inside the outer spool, Figure 20. Push the inner reel and outer spool together. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the reel.

Eyelets

FIGURE 20

NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment.

14.Hold the inner reel in place and install the bump knob by turning clockwise. Tighten securely.

12