ASSEMBLY INSTRUCTIONS
ASSEMBLING UNIT AS A BLOWER

Blower Tube Assembly

WARNING: To prevent serious personal injury, stop

the engine and allow the impeller to stop before attaching or removing tubes.

WARNING: To prevent serious personal injury or

damage to the unit, the blower tube must be installed while operating this unit as a blower.

NOTE: If the unit was assembled as a vacuum unit, remove all vacuum parts and store away in a secure place for later use.

Installing

•Install the blower tube over the blower outlet and push it on until both tabs snap into place (Fig. 1).

Removing

•Remove the blower tube by pressing both tabs at the same time and pulling off the blower tube (Fig. 1).

Tabs

Blower

Outlet

Fig. 1

ASSEMBLING UNIT AS A VACUUM

To assemble the unit as a vacuum, begin by removing the blower tube. Refer to the previous section.

Vacuum Tube Assembly

WARNING: To prevent serious personal injury, stop

the engine and allow the impeller to stop before attaching or removing tubes.

WARNING: To prevent serious personal injury or

damage to the unit, always install vacuum tubes and the vacuum bag, and make sure the vacuum bag is completely zipped closed when operating this unit as a vacuum.

NOTE: If the unit was assembled as a blower unit, remove the blower tube and store away in a secure place for later use.

Installation

1.Align the small arrow on the lower vacuum tube with the arrow on the upper vacuum tube (Fig. 2).

Upper Vac Tube

Lower Vac Tube

Fig. 2

2.Grasp the lower and upper vacuum tubes firmly with both hands, and push the lower vacuum tube into the upper vacuum tube. Turn the lower vacuum tube clockwise until it snaps into detente and locks. When properly assembled, the dot on the lower tube aligns with the dot on the upper tube.

3.Flip the unit so it is standing straight up on the muffler cover. The front of the unit and the vacuum door should face you (Fig. 3).

Vacuum

Door

Fig. 3

8