Yard Machines 570 manual Hardware Pack

SECTION 5: HARDWARE PACK

Please identify each piece of hardware in the hardware pack with the following illustrated list. This illustrated list is divided into sections according to the mower assembly procedure. For convenience in assembly, sort out the hardware according to the sections given here. NOTE: The actual number of hardware pieces necessary for an assembly procedure is given in parenthesis after each description. For actual location of the hardware on the unit, refer to parts list at the end of this manual.

Chute to deck:

Carriage Screw (2) 1/4-20 x 1.0

Flat Washer (2)

.28 ID x

.74 OD

Lock Nut (2) 1/4-20

Handle bracket to deck:
Hex Bolt (2)
3/8-16 x .75
Flat Washer (2)
.385 x 1.0 OD
x .135
Bell Washer (2)
.401 x .870
x .063
Handle bracket
to handle:
Hex
Nut (2)
3/8-16	Self-Tapping
	Screw (2)

Rear wheel to handle bracket:

Bell Washer (2)

.401 x .870 x .063

Rear Axle
Bolt (2)
.500 x 2.62	Spring
	Washer (2)

Bell Washer (2)

.39 ID x 1.13 OD x .062

Hex Nut (2) 3/8-16

Flat Washer (2)

.510 x 1.373 x .04

Handle bracket through handle & deck:

Hex Screw (4) 5/16-18

Hex

Flange

Lock

Nut (4)

Front wheel to deck:

Bell Washer (2)

.401 x .870 x .063

Bell Washer (2)

.39 ID x 1.13 OD x .062

Hex Nut (2) 3/8-16

Upper handle to lower handle:

Carriage Bolt (2) 5/16-18 x 1.5

Hex Nut (2) 5/16-18

Lock washer (2)

Starter rope guide:

Eye Bolt (1)

Lock Nut (1) 1/4-20

Front axle bolt (2)

.498 x 1.635

Cable to handle: (illustrated in half size)

Cable tie (1)

7