Yard Machines 580 Series Operation, Gas and Oil Fill-Up, Drive Clutch Control, Recoil Starter

Models: 580 Series

1 28
Download 28 pages 3.75 Kb
Page 13
Image 13
Drive Clutch Control

Drive Clutch Control

Squeeze the drive clutch control against the upper handle of the mower to engage the drive mechanism and move the wheels. Release the drive clutch control to slow down the mower when negotiating an obstacle, making a turn, or stopping the mower.

Recoil Starter

The recoil starter rope is attached to the handle. Stand behind the unit and pull the recoil starter to start the unit.

Blade Control Handle

WARNING: This control mechanism is a safety device. Never attempt to bypass its operations.

The blade control handle is located on the upper handle of the mower. See Figure 12. The blade control handle must be depressed in order to operate the unit. Release the blade control handle to stop the engine and blade.

WARNING: The blade will be rotating whenever the engine is running.

Throttle Control (Optional)

Your lawn mower may be equipped with one of three types of throttle controls described below. Follow instructions which pertain to your unit.

1.The throttle control is located on the left side of the upper handle. It is used to regulate the engine speed.

2.The throttle control is located on the engine. It is used to regulate the engine speed.

3.The mower engine is equipped with a constant speed throttle, which is set at full throttle for best performance.

WARNING: The throttle control cannot be used to stop the engine. Also if your mower’s throttle control is located on the engine, do not adjust the throttle control while the engine is running.

Primer (If equipped)

The primer is located on the engine as shown in Figure 12 and is used to pump gas into the carburetor. Use it to start a cold engine, but do not use it to restart a warm engine after short shutdown.

Height Adjustment Lever

The height adjustment lever is located on each wheel and is used to adjust the cutting height. See Figure 12. All four levers have to be put at the same level for uniform cutting height.

SECTION 9: OPERATION

WARNING: Keep hands and feet away from the chute area on cutting deck. Refer to warning label in Figure 2.

The operation of any lawn mower can result in foreign objects being thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields. We recommend wide vision safety mask for over spectacles or standard safety glasses.

Gas and Oil Fill-Up

Service the engine with gasoline and oil as instructed in the separate engine manual packed with your mower. Read instructions carefully.

WARNING: Never fill fuel tank indoors, with engine running or until the engine has been allowed to cool for at least two minutes after running.

13

Page 13
Image 13
Yard Machines 580 Series manual Operation, Gas and Oil Fill-Up, Drive Clutch Control, Recoil Starter, Blade Control Handle