ASSEMBLY INSTRUCTIONS
LOOSE PARTS LIST
Assemble the following parts in accordance with the instructions on the following pages.
•Hopper Assembly
•Connecting Tube Assembly
•Hex Wrench
•5 Safety Set Screws M5 X 15
•2 Split Pins
•2 Wheels
•2 Flat Washers 12mm
•2 Hex Screws M8 X 40
•2 Flat Washers 8mm
• 2 Spring Washers 8mm
• 2 Wheel Covers
Fig. 3
HOW TO ASSEMBLE YOUR SHREDDER (FIG. 3)
1.Push the large diameter section of the axle into the axle tube and secure the axle into position using the M8 x 40 hex screws and star washer. (2 per side)
2.Push the wheel and then the 12mm flat washer over the axle.
3.Push the split pin through the hole in the end of the axle and bend the ends over using pliers.
4.Fix on wheel covers.
HOPPER (FIG.4) Place the hopper on top of the feed tube and align the fixing holes. Secure with the safety set screws.
Fig. 4
OPERATING INSTRUCTIONS
Read and understand
CAUTION: the safety instructions in
this owners manual before using your Shredder. Failure to comply can result in acci- dents involving fire, electric shock, or serious personal injury.
1.Connect the Shredder to a suitable power outlet.
2.To start and stop the Shredder, depress the switch located at the rear of the Motor (Fig. 5)
OVERLOAD PROTECTION AND MOTOR
JAMMING If overfeeding clogs the machine the overload protection switch may cut out the motor. To restart, firstly switch the machine off and disconnect the power cord.
Loosen caging knobs and remove top cover assembly, then remove any clogged debris from the cutting cham- ber. If the top cover assembly becomes jammed and will not lift off, turn the
ON/OFF
SWITCH
OVERLOAD PROTECTION
SWITCH
Fig. 5
8