MAINTENANCE
5.Hardware: Stop engine and remove key thoroughly inspect the entire machine for any missing or loose hardware. Check daily.
6.Air cleaner: Stop engine and remove key. Remove plastic cover and loosen wingnut on the air cleaner. Remove the foam
7.Engine oil: Change oil to manufacturers specifications. Stop engine and remove key. Drain oil when engine is warm. Thoroughly clean around cap before removing. Remove oil drain cap from the end of drain hose located at the right rear of unit allow to drain and replace drain cap. Remove oil filter and replace. Put a light coat of clean oil on the filter gasket before installing. Fill engine with oil using manufacturers specs, see specification sheet. The factory uses Quaker State Super Blend
8.Hydraulic oil: Check daily. Stop engine and tilt seat forward.Thoroughly clean around cap. Remove cap. Oil level should be 1/4” to 1” below the neck of the tank. If not, add oil. NOTE: Use only 20w - 50 motor oil, see specification sheet.
9.Tire pressure: Check every 25 to 50 hours.All four tires require 15 psi.
10.Battery: Check every 25 hours. Check electrolyte level. If needed fill to the full line marked on the side of the battery. Fill with distilled water. Do not try starting the engine with a weak battery. Recharge or replace the battery. The engine condensers and electronic iginition can be damaged internally with less than or more than the required 12 volts.
11.Belts: Check every 25 hours. Stop engine and remove key. Check the condition of all belts. The pump belt located under the seat and rubber engine flap. The front deck belt and the mule drive belt.
12.Lubrication:
Front caster pivots - every 25 hours.
Front wheels - every 25 hours.
Deck lift blocks - every 25 hours.
Park brake assemblies - every 25 hours.
Struts - every 25 hours.
Deck lift pivot - every 25 hours.
(Clean grease zerk thoroughly before greasing)
PRINTED IN USA | 12 | MANUAL NO. 102936IR |
