INSTALLATION INSTRUCTIONS
Because each installation is unique to the property, it is not possible to give full details to suit every setting. However the installation should comply with the
1.6Typical top flue installation. Flue to be installed in accordance with manufacture’s instructions.
requirements of the Building Regulations and be made using ‘best practice’ construction methods. Remember that many fireplace openings will have a supporting lintel. Do not remove this without making provision to support the remaining structure of the building. The Elegance stove must not form any part of the supporting structure.
1. INSTALLING THE STOVE
600mm 
minimum 1000mm maximum
To chimney connection as detailed in building regulations
| 135° | Elbow | ||
| ||||
| Size |
| Stovax Part No | |
|
| |||
| 5” |
|
| 4512 |
| 6” |
|
| 4612 |
Flue Pipe 915mm (3ft)
Size Stovax Part No
5” 4502
6” 4602
1.1Remove all packing and temporary transportation fixings from the Elegance stove, check that no parts have been left in the ashpan.
1.2Lift the stove into position on the prepared hearth area, taking care not to damage the hearth finish.
1.3Connect the stove to the chimney system, using Stovax enamelled flue pipe and seal the connecting joints. Typical top and rear flue connections are shown.
1.4Top flue pipe installation
Flue Pipe 915mm (3ft)
Size Stovax Part No
5” 4502
6” 4602
Seal Collar with Fire Cement
1.7As it is not possible to fully sweep the flue through the stove, provision must be made to clean the flue and collect debris without removing the stove.
1.5Connect a flue pipe by inserting it into the flue spigot and sealing using fire cement.
11
