MAINTENANCE
MOTOR
The blower motor should be cleaned annually and if it has oiling ports, it should be oiled with a good grade of SAE 20 oil. Normally a few drops of oil in each bearing is sufficient.
COIL
The coil must be kept clean by any of the following methods.
1.Cleaning with
2.Flushing or rinsing with water (a detergent is advisable for greasy surfaces).
FILTERS
Clean or Replace Air Filters Regu- larly
The intervals at which filters require replacement depend on local conditions.
Because of dust and lint in the room,
To ensure proper maintenance of the filters, it is best to follow an organized maintenance procedure. The following one is recommended:
Divide the total number of units on the job into six equal groups. Each week inspect, clean or replace the filters in each group, in rotation. This insures a uniform servicing interval. The interval may be lengthened or shortened as determined by experience. If inspection shows only the
Dirty filters reduce the air and heat- ing capacities of the Unit Ventilator. When the filters are excessively dirty, the unit heating capacity will be so re- duced that it is ineffective for heating the room. When a room fails to heat, always check the filters.
CLEAN UNIT INTERIOR
Once a year clean the fans and coils of the unit thor- oughly. Remove the access panel as necessary.
Wipe the interior of the unit clean with a rag. Wipe the motor and inside and outside of the fan housings. (In cooling units, clean out the drain pan.)
P.O. Box 1592, York, Pennsylvania USA | Tele. | Subject to change without notice. Printed in USA |
Copyright © by York International Corporation 2004 | www.York.com | ALL RIGHTS RESERVED |
Form |
|
|
New Release |
|
|
