Yorkville Sound YS1031 owner manual Ii. Subwoofer Level Control, Limit, Clip Indicator LEDs

RIGHT

RIGHT

ii. Subwoofer Level Control

The Subwoofer

Level control allows fine-tuning of the low frequency output. Adjustments can be made to compensate for signal sources that are not the standard +4 dBv level.

3.Clip Indicators

LEFT

LEVELCLIP

STEREO

MONO LIMIT

00 dB 12

LEFT I N P U T S

BAL

LEFT PARALLEL INPUTS

				i. Limit
				Indicator LED
				The Limit Indicator
RIGHT			SUBWOOFER	LED indicates
LEVEL		SUB CLIP	LEVEL	when the maximum
		SUB LIMIT		operating level for
00 dB 12			00 dB 12	the satellites has
				been reached.
				When the LED is
		AUX BAL		illuminated, the
				circuitry is actively
		SUBWOOFER IN
	INPUTS
				limiting the output.
				Increasing the
	PARALLEL
			BAL	input signal level
				or turning up the

i. Clip Indicator LEDs

The Clip Indicator

LED shows when there is ex-cessive input level on either the Left or Right Inputs.

ii. Sub Clip Indicator LED

The Sub Clip Indicator LED indicates excessive levels for signals going to the subwoofer amplifier. Indications of excessive levels are monitored either from the signals being sent from the Left and Right Inputs or from the Aux Bal Subwoofer In jack.

4. Protection

The éXcursion 2000 uses a sophisticated, multi- stage limiting system that prevents clipping of the amplifiers while accommodating a wide range of input levels. The limiter circuitry protects the entire system against most instances of overpowering.

Note: Continuous acoustic feedback may cause damage to the light bulbs (CTL™ horn protection circuitry) or to the speakers in the satellites.

1/4-inch T.R.S.

Phone Plug

Tip = 0°

Ring = 180°

Sleeve = Ground

Level controls will not increase the operating level beyond the limit

indicated. When the unit is driven into limiting, the internal Limiter circuit becomes triggered and will reduce the gain. This will not significantly degrade the sound quality.

Note: Operating a few dB into limiting will ensure that the system is operating at its maximum output. Operating excessively into limiting will make the system more susceptible to feedback.

ii. Sub Limit Indicator LED

The Sub Limit Indicator LED illuminates when the maximum recommended operating-level of the subwoofer has been reached. Increasing the input signal level or turning up the Level controls will not increase the operating level beyond

the limit indicated. When the internal Limiter circuit becomes active the sound quality will not significantly be degraded.

XLR Plug

(Male)

Pin 1 = Ground

12 Pin 2 = 0°

3Pin 3 = 180°

Balanced 1/4-inch T.R.S. to Balanced XLR

2