Zadro Products TRANQUIL SOUNDS OXYGEN BAR manual Operation, Getting started, Operating Procedure

*

*In areas of high humidity, use the condensation chamber to collect excess water condensate from the unit.

Note: Using the condensation chamber will reduce airflow. Use only if necessary.

Danger

Check the electrical rating on the	When the power cord is found
unit label and wall outlet before	damaged or broken, send it to your
connecting the power cord.	dealer or authorized service center
	for examination or repair.
Infant, child, or disabled people	Do not attempt to open cabinet. If
should use under the watch of other	service is required, return unit to a
adult to avoid accidental injury.	qualified dealer or an authorized
	service center. Opening or
	tampering with the unit will void
	warranty.
Please remove the plug from	Keep the unit and all electrical
	cords away from heated surfaces
electric outlet when not in use.	or appliances. The oxygen will
	make the material flammable.
Do not use while bathing or	Do not reach for the unit in the event
	the unit falls into water. Unplug the
with wet hands.
	unit immediately, then send it to your
	dealer or authorized service center
Operation	for examination or repair.

Getting started

1 Open the box containing your Tranquil Sounds Oxygen Bar, check the contents and make sure the following components are enclosed: Oxygen concentrator unit Headset and hose (including optional condensation

chamber)

Operation manual

2 If there are missing items, please contact the dealer where you purchased your Tranquil Sounds Oxygen Bar.

3 Read user manual carefully.

4Connect the hose provided to the oxygen outlet on the side of the Oxygen Bar.

Operating Procedure

1	Place unit on a stable, flat surface which is clean
	and free of dust. Do not set base on carpet or
	other soft surface as this could cause air flow
2	restriction and damage to unit.
	Check to see that the power switch is in the "	"

(OFF) position. Plug power cord into electrical outlet.

3Press the power switch to " " (ON) position. The power switch is located at the back of the machine in the lower bottom corner. When the power switch is turned on it is in “stand by” status and there is no indication light.

4Position the headset over your ears and adjust the position of the flexible arm.

6