Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it under a close fitting sink unit or a
Proceed as follows:
-Remove the machine’s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.
The WRD detergent dispenser
If the programme has a prewash add the required detergent
in the WRD detergent dispenser, located in the centre of the upper basket.
Check that the WRD is not clogged with detergent residue. If necessary rinse it under running water after having removed it from the basket by twisting it anticlockwise and pulling it upwards.
Fasten it back onto the support by turning it clockwise.
Never use your dishwasher without the WRD dispenser.
Since WRD also ensures correct distribution of the water to the upper spray arm, running the dishwasher without it will impair the washing results.
570 | - |
| 600 |
820 |
|
600 |
|
IN05 |
|
DE13 |
MA11 |
21
