Contents
How to install the stand on your washing
machine _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2
How to install the stand on your tumble dryer _ _ _ _ 4
Subject to change without notice
How to install the stand on your washing machine
Warning! Do not install the stand on a washer/dryer column.
Caution! If the washing machine is already connected to the mains, proceed as follows:
1.pull out the plug from the mains;
2.stop water supply by closing the tap;
3.disconnect the inlet pipe and the drain pipe and get ready to collect any water left in the machine with a shallow basin.
Important! With a brand new washing machine, do as follows:
1.install the stand before connecting the machine to water and electricity mains;
2.follow the instructions to remove any transport safety
equipment.
Before you start installing the stand on your washing ma- chine make sure you have plenty of room. Avoid working in restricted spaces as the installation and subsequent adjustment operations may turn out quite awkward and difficult to carry out.
Take the stand out of its package and use the cardboard to rest washing machine and stand on, so you wont scratch the equipment varnish and the floor.
In the stands drawer you will find an envelope with all the necessary material for a correct assembly.
Have ready a Phillips screwdriver to fit rear brackets to the stand and to fit rear brackets to the machine.
The pack includes:
•4 front rubber feet (for tumble dryer only);
•6 rear metal brackets (4 for washing machine and, de- pending on the model, 2 for tumble dryer);
•6
•1 key to adjust stand feet.
Important! Before starting the installation, adjust the stand's feet in order to achieve a perfectly stable hori- zontal position.
fig. 1
Proceed as follows (fig. 1):
•loosen the nuts using the key supplied with the stand;
•adjust the feet to allow for an uneven floor;
•tighten up all check nuts.
fig. 2 | fig. 3 |
Before picking the rear brackets you must first look at the machines side (fig. 2 and 3).
fig. 4 | fig. 5 |
2