The stand is now installed; check whether your washing machines back feet rest on it (fig. 16). Otherwise undo them using the key supplied with your washing machine (fig. 17).
fig. 18 | fig. 19 |
The stands drawer, with a capacity of up to 20 kg, con- tains two dividers; they may be taken out if you wish (fig. 18). The drawer was designed with a special com- partment inside where you can place a folding plastic box, supplied, quite useful to store your washing laun- dry (fig. 19).
fig. 20 | fig. 21 |
The drawer slides on two metal runners and can easily be pulled out to the full. Should you wish to remove the drawer, you must pull it out completely (fig. 20) and act on the two black plastic levers halfway through the metal runners. Pull the right lever down and the left lever up: the drawer will be uncoupled from the runners and easily removed (fig. 21).
Warning! Do not place any solvent or flammable substance into the drawer, as the fumes could be a
possible cause of fire.
How to install the stand on your tumble dryer
Warning! Do not install the stand on a washer/dryer column.
Caution! If the tumble dryer is already connected to the mains, proceed as follows:
1.Pull out the plug from the mains;
2.remove the condensation tank found in the upper or alternatively lower part of the tumble dryer (according to machine type) and empty it, if necessary;
3.Drain off any condensation water through the hose found on the lower part of the machines back (fig. 1). Place a mop on the floor and remove first the clamp
(A) using a pair of pliers, then the cap (B). Tilt the machine slightly on one side. When all the water has drained off, put the cap back onto the hose and re- fasten the clamp.
A
B
fig. 1
Important! With a brand new tumble dryer, do as follows:
1.install the stand before connecting the machine to the mains;
2.follow the instructions to remove any transport safety
equipment.
Before you start fitting the stand to the machine make sure you have plenty of room. Avoid working in restricted spaces as the installation and subsequent adjustment operations may turn out quite awkward and difficult to carry out.
Take the stand out of its package and use the cardboard to rest machine and stand on, so you wont scratch the equipment varnish and the floor.
4
