Zanussi ZAF 42 manual Important safety requirements, Location

Important safety requirements

This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition).

Detailed recommendations are contained in the following British Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891 Current Editions.

The hob should not be installed in a bed sitting room with a volume of less than 20 m3. If it is installed in a room of volume less than 5 m3 an air vent of effective area of 110 cm2 is required. If it is installed in a room of volume between 5 m3 and 10 m3 an air vent of effective area of 50 cm2 is required, while if the volume exceeds 11 m3 no air is required.

However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m3 and 11 m3.

If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements.

Location

The hob may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom or shower room.

Before making the cut out in the worktop ensure that there is a minimum distance of 55 mm. between the rear edge of the hob and the wall.

A minimum distance of 100 mm. must be left between the side edges of the hob and any adjacent cabinets or walls.

The minimum distance combustible material can be fitted above the hob in line with the edges of the hob is 400 mm. If it is fitted below 400 mm. a space of 50

mm.must be allowed from the edges of the hob. The minimum distance combustible material can be fitted directly above the hob is 700 mm.

INSTALLATION GUIDANCE INSTRUCTIONS

CLEARANCES REQUIRED

WHEN FITTING THE GAS HOB

WITHOUT A COOKER HOOD ABOVE

700 mm
	400 mm
			mm
	50		55
		mm		400 mm
100	mm
			50	mm

INSTALLATION GUIDANCE INSTRUCTIONS

CLEARANCES REQUIRED

WHEN FITTING THE GAS HOB

WITH A COOKER HOOD ABOVE

600 mm

700 mm

	400 mm
			mm
	50		55
		mm		400 mm
100	mm
			50	mm

FO 0812

FO 0813

11